Fu10 Day Watching 18 Install (Direct)

Mount the FU10 2.5–3 meters high. For day watching, tilt the camera 15–20 degrees downward to avoid direct horizon glare during 10 AM–2 PM peak sun.

Run a shielded Cat6 cable (max 100m) for power over Ethernet (PoE) plus a separate BNC for analog fallback. Avoid running parallel to AC power lines. Phase 2: Power-On & Network (Steps 5-8) Step 5: Initial Boot Connect power. The FU10 will take ~45 seconds to initialize. Watch for the green LED (steady = good; flashing = SD card error). fu10 day watching 18 install

Press and hold the reset pinhole for 10 seconds until you hear two beeps. This ensures no legacy settings interfere with day-watching profiles. Mount the FU10 2